MeiTrack VT310 User Manual download pdf (Page 6)

To bind a CT-03 device to a specified Account/Device record, set the "Unique ID:" field on the Device Admin page

to the appropriate prefixed unique-id value. For example:

Unique ID: ct03_123456789012345

Or, on the CT-04 device:

Unique ID: ct04_123456789012345

2.3) Setting the Device Communication Server Properties

Properties which effect the behavior of the server are set in the "Properties" tag section. The following

properties may be set:

This is the minimum acceptable speed value, below which the device will considered not moving, and the speed

will be explicityly set to "0.0".

If "true", the DCS will replace an event which otherwise is defined to be a general STATUS_LOCATION status

code instead with a STATUS_MOTION_IN_MOTION status code, if the indicated speed of the vehicle is greater

than zero.

If the specified value is greater than '0', then subsequent received events will be omitted if they are within the

specified number of meters to the previous event. Useful for eliminating multiple events at the same location,

when the device continues to periodically report a location even if the device is stopped.

<Property key="useLastValidGPSLocation">false</Property>

If the current GPS location is invalid, and the StatusCode is "STATUS_LOCATION", then use the last known GPS

location from the 'Device' record as the current GPS location. The StatusCode will be set to

"STATUS_LAST_LOCATION", and the "GPS Age" will be set to the elapsed time since the previous valid GPS

location.

If "true", the DCS will calculate the current event odometer based on the distance traveled since the last valid

GPS location.

If "true", the DCS will check for geozone arrivals/departures and insert the appropriate arrive/depart events.

If specified, this mask value indicates which of the digital inputs should be check for state changes, and if a state

change is detected, an event with the appropriate digital input state change status code will be generated. The

special value "false" is the same as entering a mask value of "0", which indicates that no digital input state

changes should be detected.

GTS Enterprise Installation/Configuration Guide Page 6 of 13

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

MeiTrack VT310 User Manual Page 6